Fast Free Shipping Over $99
30+ Years ofExpert Advice
855-921-7900
EXPERT ADVICE &
PROFESSIONAL ASSISTANCE

Call Us Toll Free 24/7!
855 921 7900
Weight: 1.00 lbs.
Availability: In Stock
Usually ships In Within one business day or same day
Price: $261.28

    Quantity:

    Free shipping over $99 click for details


    Quantity

    2-45-910+

     Price Each 

    $256.05$248.22$235.15

    8ga black monofilament 1200lb breaking strength tension cable (suggested for customers installing a fence on both posts and trees) to tension 330 linear feet

    • 1000 feet of cable, enough for two positions, top and one more - typically 30" or where the top poly fencing meets the bottom rodent barrier fencing (if applicable)
    • 20 large 8ga Gripple tensioning connectors - hardware used to splice and tension your cable every other post in a loop method (see below for details)
    • 42 black eye bolts for trees

    What's not included:

    • Corners and ends (suggested for right angles) which brace against the tension put on the fence, found here: corners and ends
    • 2 1/2 collars for corners and ends, need two for each corner or end purchased, found here: 2 1/2 post collars
    • A hogringer hand tool (fence ties can be used also) to connect each strand of cable to your fencing. A 11/16 ringer with 1000 rings is found here: 11/16 hogringer or 9/16 commercial grade ringer found here: 9/16 ringer
    • For large projects, a Gripple tensioning tool. Allows for highest possible tension. Corners and ends must also be used. Tool found here: Gripple Tensioning Tool
    • Post cable collars for posts

    Loop method installation detail:

    To install tension cable in the standard way, you would have collars positioned at the top of every post and another collar at 30" (the deer impact zone) or at the height of your rodent barrier fencing (if applicable - for example if you have a 2ft rodent barrier, this cable would be at 18" high leaving you 6" of overlap on the ground).

    A loop is created using cable every three posts with a gripple tensioning connector joining the cable together at the bottom middle post collar.

    For example, to run the cable, start at the middle bottom collar and run the cable through to the right bottom collar, up to the right top collar, over to the middle top collar continuing over to the left top collar, down to the bottom left collar and meeting back in the middle bottom to join with the other end of the cable and gripple tensioning connector.

    This will give you separate, independent panels to tension. Run all your tension cable first loosely and tighten in sequence. You can then go back with a level on each post and pull posts in and out of plumb to adjust. Feel free to call with questions.

    Active now this week: